How to Finish the Back of a Picture Frame

How to Finish the Back of a Picture Frame

Do you agree that accomplishing Acrylic Frames and Custom Picture Frames are great? Below are instructions to how you seal and finish the back of the frame before hanging or selling. The objective of finishing the back of a frame is to:

1. Cover it to avoid dirt, ticks and moist from entering the mount, and Art Reproductions beneath the glass.
2. Make it look specialized and spotless to the eye.
3. Deliver hanging ideas to hang the photo.
4. Arrange for immovability from motion and wall safety.

The theory is that you already have Custom Picture Frames, or pre-made with sealing, Photo Mounting Board and backing board cut to size and fastened. The backing board must also be able to deliver numerous degree of moisture safety such aqua board or alike.

Step One:

Fasten the backing board, base, artwork, and sealing sandwich in to Custom Picture Frames, refund with flexi points, semi unbending points or other same framer’s points and tabs. These can be ablaze in with a tab gun or physically pushed in.

Step Two:

Use the frame backing tape such self-adhesive tape on each boarder to create the dust cover. Cut the tape with a master knife after finishing each side. Being cautious not to ruin the side of the frame. After sealing, then cutting the tape edge on all 4 boarders.

Step Three:

Estimate the edges of the frame 1/3 of the way down from upper edge. Mark with a pencil or tool. Afterwards, make a surface opening hole in the frame with the bradawl. Do it again on other side of the frame. Hence, you have two identical holes for creating a screw thread on every side of the Picture Frame Moulding.

Step Four:

Fasten a D-Ring to every side of the frame using a pan headed bolt to hole it in position. The frame should already be prepared to secure picture cable or rope.

Step Five:

Fasten cord to each d-ring and affix in place by use of a loop. If possible one that binds on itself under pressure. Step Six: Fasten two felt or other parallel cushion pads to every lower angle of the frame. This will help halt the frame shifting on the wall plus help stop the frame from marking the wall. It will also produce an air hole and let air to flow behind frame. The frame backing method is done. It’s time to hang your picture on the wall!

One of the various advantages of having a picture or work of Art Reproductions is the awareness to not merely the front of the frame. Also the appearance of the output, yet the back of the frame and the maintenance of the art. The experts know that taking several additional steps on the back of Custom Picture Frames can help safeguard the work inside for years to come. One important tip, though, moisture must constantly be repelling from art and framing. Study the accurate process for application, and the dust cover will often be taught without the addition of moisture. On the other hand, what if you’re doing your framing yourself? It is still likely to get expert-quality picture security by placing a dust shield backing on your picture frames. Better still: it’s simpler than it sounds.

Leave a Reply